R&D Services

Material Evaluation & Testing、Electrode Fabrication、Cell Fabrication、Electrical & Safety Testing、Failure & Root Cause Analysis

Three-Electrode Battery Test Mold 01

$1026.94

Numéro d'article:MA-CM-TO-006501

Spécifications

✓ Sélectionné: Organic

Assurance qualité

Vente directe usine

Livraison mondiale

Details

Aperçu

Spécifications

Détails

This product is developed for performance testing of aqueous and organic three-electrode batteries, suitable for use in Swagelok-type cell configurations. Constructed from Peek material, it offers reliable sealing and ease of operation, with a design that supports both large-scale electrolyte tests (without separator) and trace electrolyte studies (with separator and wire reference electrode). The module allows customization of electrode dimensions and replacement of the reference electrode, with common electrode sizes ranging from 10–12 mm for compact setups. It is specifically intended for laboratory research on battery materials and electrochemical characterization.

Applicable for performance testing of various aqueous/organic three-electrode batteries.

Three electrodes Swagelok cell test

Mold usage method

1. Water based electrolyte battery testing (used for large-scale electrolyte testing without the need for a separator)

Preparation materials: electrode (cathode, anode), electrolyte, Ag/AgCI reference electrode

1) Fix the electrode pads onto the current collectors at both ends of the mold and install them onto the electrodes, tightening them with nuts at both ends. The electrode spacing is adjusted according to the amount of electrode solution added.

2) Add electrolyte using a dropper.

3) Insert the reference electrode, adjust the height, and tighten the seal.

2. Organic electrolyte system battery testing (for trace electrolyte testing)

Preparation materials: electrode plates (positive, negative), electrolyte, wire metal reference electrode, separator

1) Insert a current collector into the appropriate position and tighten the nut. And place the electrode and separator in it, and drip the electrolyte.

2) Insert the reference electrode wire, note that the metal wire cannot be circular, so that the metal wire comes into contact with the diaphragm.

3) Add another layer of separator and drop electrolyte to clamp the reference electrode between the two separators.

4) Insert the other electrode, insert the current collector, and tighten the nut cap.

Specific dimensions of the electrode need to be specified when placing an order.

Material: Peek

Features: Good sealing performance, convenient to use. The electrode can be customized according to requirements, and the reference electrode can be replaced (the price on the page includes working electrode, counter electrode, and reference electrode).

Common electrode size: 10-12mm, suitable for smaller sizes.